手机捕鱼下载

  • What are the requirements for wall thickness of plastic parts

    The wall thickness of plastic parts has a great influence on the quality. When the wall thickness is too small and the flow resistance is large, it is difficult for large and complex plastic parts to

    2018-03-08

  • What are the commonly used injection moulding materials?

    手机捕鱼下载 Injection materials commonly used in injection moulding and plastic materials suitable for injection moulding, including PE PP PS and other plastics, have thermoplasticity and are suitable for hot inj

    2018-03-08

  • Analysis of the Defects of Plastic Formation

    The reasons for the shortcomings in the processing of plastic parts are as follows:1. Injection material. Material has impurities or supplies from different suppliers, different batches from the same

    2018-03-08

  • What should be considered in the design of injection moulds

    手机捕鱼下载 1. Considering the process characteristics of plastic raw materials, the moulding performance and the type selection of injection moulding machine may have an impact on the moulding quality, so corres

    2018-03-08

Previous page1Next page Go to No.